Replacement water temperature sensor kit for Classic furnaces with a Digital Temperature Controller (p/n 2000155), Forge models and Classic Edge HD models. Includes sensor and wire lead, mastic tape and instructions.
ThermoPEX insulated piping saves energy and maximizes efficiency by keeping heat loss to a minimum. Greater system efficiency maximizes the delivery of heat from each pound of wood. That reduces wood consumption. Less than 1° of heat loss per 100 foot.
This pipe is sold in 25 foot increments and is cut to the length. Give us a 1-2 day lead so we can get the pipe cut and tied for you.
The Taco 009 Circulator is designed for use in high head and low flow applications in hydronic heating and radiant heating. Features a field-serviceable cartridge which allows you to replace the cartridge without replacing the entire circulator. The pump's maintenance-free design provides unmatched reliability. See the data sheet under attachments for pump specifications.
The Taco 007 Circulator is small but mighty. This unique pump features a replaceable cartridge contains all the moving parts and allows the circulator to be serviced instead of replacing the entire unit. The quieter direct drive cartridge type "00" series circulator is self-lubricating, contains no mechanical seal, and requires no maintenance. This compact low power consumption design is ideal for those high-efficiency jobs. See the data sheet under attachments for pump specifications.
Corrosion Inhibitor helps protect exchangers and pumps against solids adhering to system parts. It also inhibits rust and corrosion to your firebox from the inside by treating the water. One gallon of rust inhibitor treats 200 gallons of water.
This kit includes door seal rope cut to length(10 ft), black silicone adhesive and instructions. For Classic 4030, 5036, 6048 model firebox doors, Hydrofire models and Forge 1500, 3500 model firebox doors. For cast door and steel door models if applicable.
Forge 1500/3500 uses 6.5 ft Classic 4030/5036 uses 8 ft Classic 6048 uses 9 ft
Because damper control solenoids are not always interchangeable, check measurement and application dates carefully. Solenoid (p/n 4184) has a 1-3/8" center-to-center bracket hole (for models after June 2000, including all E-Classic models).